:SENSe:CORRection:LOAD

Description

Gets or sets the resistance value in Ω used for the load calibration.

Note

The load value can only be set, if the selected measurement mode supports a load calibration. Otherwise a Settings Conflict error is raised.

Command
Query

Syntax	Parameter
`:SENSe<ch>:CORRection:LOAD`	<`numeric`>

Parameters	accepted format	allowed suffixes	possible Errors	description
<`ch`>	{ `1` \| `empty` }	`none`	`Invalid channel index`	Currently only one channel is supported. `Empty` means `1` is used as default.
{ <`numeric`> \| `MINimum` \| `MAXimum` }	Range from `1Ω` to `1kΩ`	`Ohm`	`Settings conflict`	The load value in Ohm.

Syntax	Response
`:SENSe<ch>:CORRection:LOAD?`	<`numeric`>

Parameters	accepted format	description
<`ch`>	{ `1` \| `empty` }	Currently only one channel is supported. `Empty` means `1` is used as default.

Response value	description
<`numeric`>	The load value in Ohm.

Sample usage

Configure an S11 measurement, set the load value to 100 Ohm and perform the full range load calibration.

C#
Python

var visaSession = new TcpipSocket(VISA_RESOURCENAME);
visaSession.RawIO.Write(":CALC:PAR:DEF S11\n");
visaSession.RawIO.Write(":SENS:CORR:LOAD 100Ohm\n");
visaSession.RawIO.Write(":SENS:CORR:FULL:LOAD\n");
visaSession.RawIO.Write("*OPC?*\n");
visaSession.RawIO.ReadString();